User Manual

4EN
REQUIRED FOR COMPLETION
# Required Part # Description
1 DLEG0130 DLE-130cc Twin Gas Engine with EIectronic Ignition
1 DLEG0170 DLE-170cc Twin Gas Engine with EIectronic Ignition
1 EVOA112 Evolution 3 Wire Ignition/Receiver Switch
1 HAN116 Fuel Filler with "T" and Overfl ow Fittings
2 SPMA3003 Heavy-Duty Servo Extension 12-inch
2 SPMA3004 Heavy-Duty Servo Extension 18-inch
4 SPMA3005 Heavy-Duty Servo Extension 24-inch
2 SPMA3006 Heavy-Duty Servo Extension 36-inch
2 SPMA3007 Heavy-Duty Servo Extension 48-inch
1 SPMAR12310T AR12310T 12CH PowerSafe Telemetry RX
2 SPMEXEC324 24-Inch EC3 Extension with 16AWG
7 SPMSA6310 A6310 U-T/H-S Brushless HV Servo
1 SPMSA6380 A6380 H-T/H-S Digital HV Servo
6 SPMSP3101 Aluminum 1/2 Servo Arm, 1.5-inch
1 SPMSP3103 Aluminum Double Servo Arm, 2.5-inch
3 SPMX40002SRX 4000mAh 2S 7.4V Smart Receiver Battery; IC3
# Required Part # Description
1 EVOA100 Optical Ignition Kill Switch
1 SPMAS3000 AS3000 AS3X Stabilization Module
1 SPMX13003S30M 1300mAh 3S 11.1V Smart 30C LiPo; IC3
1 SPMXCA305 Connector: IC3 Device/Wire 4-inch
TOOLS REQUIRED
Description
Adjustable wrench
Balancing stand
Box Wrench Set
Clamps
Crimping tool
Drill and tap set, metric
Drill bit set, Imperial or Metric
Epoxy brushes
Felt-tipped pen
Hemostats
Hex wrench set, Imperial and Metric
Hobby knife with #11 blade
Hobby scissors
Hook and loop straps
Hook and loop tape
Isopropyl alcohol
Light machine oil
Low-tack tape
Mixing sticks
Needle nose pliers
Nut driver set, Imperial and Metric
Paper towels
Pencil
Petroleum jelly
Phillips screwdriver: #1, #2
Pin vise
Rotary tool
Ruler
Sanding bar
Sanding drum for rotary tool
Sandpaper
Scissors
Side cutters
Square
Tap handle
Tapered reamer
Tie wraps
Toothpicks
Wire stripper
OPTIONAL PARTS