User Manual

10
  Step 8
Flex the aileron up and down a number of times to break
in the hinges.
  Step 9
Use a piece of sandpaper to roughen the flap linkage
where it will extend into the flap. Use rubbing alcohol and
a paper towel to clean any residual dirt from the linkage.
This is done to give the epoxy a surface to hold onto when
the flap linkage is epoxied into the flap.
  Step 10
Prepare three more hinges using the technique in Step 1.
Drill 1/16" (1.5mm) holes in the center of each hinge slot,
both the wing and flap using the same technique as Step
2. Slide the hinges into the flap, centering the slot in the
hinge with the hole drilled in the center of the slot.
Section 1: Hinging the Ailerons and Flaps