User Manual

13
  Step 5
Mix up about a tablespoon of 6-minute epoxy to glue
the two 3/4" x 5/16" x 9/16" (19mm x 8mm x 14mm)
servo mounting blocks to the servo cover. Align the
blocks on the marks made in the previous step. A
clamp can be used to hold the blocks in position until
the epoxy fully cures.
  Step 6
Position the servo back onto the servo cover between
the blocks. With the servo slightly off the cover, mark the
location for the servo mounting screws using a felt-tipped
pen.
Note: The servo is placed slightly off the servo
cover to help isolate it from vibration and to
let the servo grommets do the job they were
designed for.
  Step 7
Remove the servo and drill the locations marked in the
previous step using a 1/16" (1.5mm) drill bit.
  Step 8
Plug the aileron servo into the receiver. Use the transmitter
to check the operation of the aileron servo. Center the
aileron trim and attach a servo horn to the servo. The
servo arm that extends out beyond the servo cover should
measure 1/2" (13mm) from the center of the arm to the
outer hole. Trim the remaining arms from the servo arm so
they won't interfere with the operation of the servo.
  Step 9
Attach the servo to the blocks using the hardware provided
with the servo.
Section 2: Aileron Servo Installation