User Manual

15
Required Items:
• Wing (right and left)
• Aileron linkage wire (right and left)
• Clevis w/retainer (2)
• Control horn w/backplate (2)
• 2mm x 11mm screw (2) • 2mm x 16mm screw (4)
Required Tools and Adhesives
• Phillips screwdriver • Drill
• Drill bit: 5/64" (2mm) • Felt-tipped pen
• T-pin
 Step 1
Locate the aileron linkages. There is a right and left
linkage as show below. (Right and left are as viewed when
sitting in the pilot's seat of the aircraft.)
  Step 2
Enlarge the outer hole of the servo arm using a 5/64"
(2mm) drill bit. Connect the appropriate aileron linkage
as shown.
Note: You may want to use painter's tape at
the wing tip to tape the aileron to the wing
tip so it will remain centered. This will make
installing the control horn much easier.
  Step 3
With the aileron servo plugged in and the radio system
on, make sure the aileron servo is centered and the trim
on the radio is centered. Slide a clevis retainer onto a
clevis. Thread the clevis onto the aileron linkage until
the pin in the clevis is 1/16" (1.5mm) behind the aileron
hinge line.
  Step 4
Use a hobby knife to trim the control horn backplate from
the control horn.
Section 3: Installing the Aileron Linkage