User Manual

Required Items:

• Left wing panel • Right wing panel

• Aluminum wing tube • Nylon strap

• #2 x 5/16" wood screw (2)

Required Tools and Adhesives

• Phillips screwdriver • Sealing iron

 Step 1

Locate the aluminum wing tube. Slide the tube into one

of the wing panels. Do not force the tube, as it will slide

easily to its correct depth.

 Step 2

Slide the remaining wing panel onto the aluminum

wing joiner tube. As the panels get close, make sure the

alignment pin goes into the hole.

 Step 3

Slide the panels tightly together, guiding the servo wires

out of the way. Use a nylon strap and two #2 x 5/16" sheet

metal screws to secure the two wing panels together.

 Step 4

If you are not planning on taking your wing apart, a piece

of covering has been supplied to cover the center joint.

You will need to use a sealing iron to apply the covering

to the center joint.

Hint: You can use 30-minute epoxy to glue

the two wing halves together. Before sliding

the wing together, apply a thin coat of epoxy

to the exposed wood of both wing panels at

the center of the wing. Slide the wing together,

then use a paper towel and rubbing alcohol to

remove the excess epoxy from the wing.

Section 4: Assembling the Wing