User Manual

Required Items:

• Assembled wing • Landing gear strap (4)

• 3

" (76mm) wheel (2)

• Landing gear (left and right)

• #4 x 1/2" sheet metal screw (8)

• 3/16" wheel collar w/setscrew (4)

• Landing gear strap (4)

Required Tools and Adhesives:

• Phillips screwdriver • Ruler

• Drill bit: 3/32" (2.5mm) • Drill

• Felt-tipped pen

  Step 1

Locate a landing gear wire. Slide a 3/16" wheel collar

onto the landing gear wire, then slide the wheel with

the recessed side towards the outside onto the landing

gear wire.

  Step 2

Slide a second wheel collar onto the landing gear

wire. Align the collar with the end of the landing gear

wire. Tighten the setscrew. Slide the wheel collar

installed in Step 1 against the wheel and tighten the

setscrew. Don't get the collar too tight which may

prevent the wheel from rolling.

Note: Use threadlock on the setscrews to

prevent them from vibrating loose in flight.

  Step 3

Snap the wheel cover onto the wheel.

Section 5: Installing the Landing Gear