User Manual

20
  Step 4
Measure in 3/4" (19mm) from each end of the landing
gear slot. Position the landing gear strap so it straddles
the slot evenly. Mark the locations for the screw holes
using a felt-tipped pen.
  Step 5
Drill the four locations marked in the previous step using
a 3/32" (2.5mm) drill bit. Be careful not to accidentally run
the drill through the covering on top of the wing.
  Step 6
Locate the left landing gear strut. Slide the strut into
position on the bottom of the wing. The wheel will be
towards the leading edge (front) of the wing when installed
correctly. Press the landing gear into the groove of the
landing gear mount.
  Step 7
Locate two landing gear straps and four #4 x 1/2" sheet
metal screws. Use a medium Phillips screwdriver to attach
the landing gear straps using the screws. Tighten the
landing gear straps until they pull the landing gear into
the groove, flush with the bottom of the wing.
Note: Use care not to over-tighten the screws
and damage the landing gear mount.
 Step 8
Repeat Steps 1 through 7 to install the remaining landing
gear strut.
Section 5: Installing the Landing Gear