User Manual

21
Required Items
• Fuselage • Engine mount
• Engine mount plate (2) • 8-32 x 3/4" bolt (4)
• 8-32 x 7/8" bolt (4) • 8-32 lock nut (4)
• 15
5
/
8
" (397mm) throttle pushrod wire
• Clevis w/retainer
Required Tools and Adhesives
• Phillips screwdriver • Ruler
• Threadlock (included in kit)
 Step 1
Use four 8-32 x 3/4" bolts to attach the engine mount to
the firewall. Pay close attention to the orientation of the
mount, as the head of the engine will face up and to the
right in relationship to the pilot.
 Step 2
Locate the engine mount plates, two 8-32 locknuts and
two 8-32 x 7/8" bolts. Slide the bolt through the smooth
side of the engine mount plate. Then slide the bolt through
the holes in the rear of the engine mount, with the curved
side of the plate towards the center of the mount. Start an
8-32 locknut onto the bolts, but do not tighten the bolt.
Section 6: Installing the Engine