User Manual

27
Required Items
• Wing • Flap linkage
• Clevis w/retainer (2)
Required Tools and Adhesives
• Adjustable wrench
 Step 1
Prepare the flap linkage by sliding a clevis retainer onto a
clevis. Prepare two clevises and then thread them onto the
flap linkage.
 Step 2
Attach the flap linkage to the forward hole in the linkage
stay. With the linkage in the forward (up) position, thread
the clevis until the flap is even with the wing trailing edge.
 Step 3
Once the flaps have been centered, disconnect the
clevis from the linkage stay and flap control horns and
move the linkage to the rear position.
 Step 4
Reconnect the clevis to the flap actuator. Slide the clevis
retainers onto the clevises to prevent them from opening
accidentally. The flaps will now be in the down, or
Training Mode.
Section 9: Installing the Flap Linkage