User Manual

Required Items:

• Fuselage • Radio plate

• Radio foam (flat) (2) • Radio foam (precut)

• #4 washer • Clevis w/retainer (2)

• Nylon pushrod keeper (2)

• Brass wire connector w/backplate and setscrew

• 4-40 x 1/2" socket head screw

• 23

" (594mm) elevator pushrod

• 26" (660mm) rudder pushrod

Required Tools and Adhesives:

• Servo w/hardware (3) • Switch harness

• Receiver • Receiver battery (flat)

• Hex wrench: 3/32" • Drill

• Drill bit: 5/64" (2mm)

 Step 1

Prepare three servos by installing the grommets and

brass eyelets following the instructions provided with

the servos.

 Step 2

Install the servos into the fuselage using the screws

provided with the servos.

Note: Even though the holes for the servo

screws are pre-drilled, it is a good idea to start

the screws and remove each one. Apply a few

drops of thin CA to harden the plywood, and

then install the servos.

 Step 3

Place a flat piece of foam down into the fuselage between

the fuel tank and the radio tray. Position the notch in the

foam towards the fuel tank.

Section 10: Radio and Linkage Installation