User Manual

33
 Step 4
Drill a 1/16" (1.5mm) hole n the center of each hinge slot
for both the rudder and fin.
 Step 5
Slide the three hinges into the rudder until the T-pin is
resting against the hinge line of the rudder.
 Step 6
Test fit the rudder and fin together. The wire from the tail
gear assembly fits into a hole that has been pre-drilled
into the rudder. The rudder and fin should fit tightly
together. If not, determine what is preventing them from
sliding together and make the necessary adjustments so
the hinge gap tight.
 Step 7
Separate the rudder and fin. Lightly sand the part of the
tail gear wire that fits into the rudder. Clean the wire with
rubbing alcohol and a paper towel to remove any dirt from
the wire.
Section 11: Preparing the Rudder Assembly