User Manual

Required Items:

• Stabilizer • Elevator (2)

• CA hinge (6) • Elevator joiner wire

• Control horn w/backplate

• 2mm x 12mm screw (3)

Required Tools and Adhesives:

• Thin CA • 6-minute epoxy

• Mixing stick

• T-pins • Drill

• Drill bit: 1/16" (1.5mm) • Paper towel

• Rubbing alcohol • Sandpaper

• Felt-tipped pen

 Step 1

Locate the elevator joiner wire. Use sandpaper to roughen

the wire. Clean the joiner wire using rubbing alcohol and

a paper towel.

 Step 2

Test fit the joiner wire into one of the elevators. It will slide

in the elevator so the wire does not protrude beyond the

hinge line of the elevator.

 Step 3

Mix up a small amount of 6-minute epoxy. Apply the

epoxy to the slot and hole in the elevator, and to the

joiner wire where it contacts the elevator. Slide the wire

into position and use tape to hole the wire in position

until the epoxy cures.

 Step 4

Test fit the remaining elevator to the joiner wire. Make

sure both elevators are parallel by resting them on a flat

surface. Either bend the wire or enlarge the hole in the

remaining elevator if necessary so both elevators are

parallel.

Section 12: Preparing the Stabilizer Assembly