User Manual

39
Required Items:
• Fuselage • Stabilizer/elevator
• Rudder/Fin
Required Tools and Adhesives:
• Pliers or adjustable wrench
 Step 1
Locate the stabilizer/elevator assembly. Locate the
fin/rudder assembly and remove the nuts and washers
from the threaded rods on the fin. Position the stabilizer/
elevator assembly so the control horn will face down,
away from the fin. The threaded rods from the rudder/fin
assembly will slide into the two holes in the stabilizer. The
fuselage fairing has been slid into position on the fin in
the photograph.
 Step 2
Thread the nuts onto the rod, tightening them snugly
against the bottom of the fuselage using pliers or an
adjustable wrench. Do not over-tighten the nuts.
Section 12: Installing the Tail Surfaces