User Manual

Required Items:

• Fuselage • Wing

• Exhaust stack (right and left)

• Decal set • Canopy

• #2 x 5/16" sheet metal screws (4)

Required Tools and Adhesives:

• Phillips screwdriver • Felt-tipped pen

• Sandpaper • Masking tape

• Rubbing alcohol • Paper towel

• Canopy glue

 Step 1

Cut the decals from the decal sheet. Use the box to aid in

the location of the decals on the fuselage and wing.

 Step 2

Position the canopy on top of the fuselage. Use a felt-

tipped pen to trace the outline of the canopy onto the

fuselage

 Step 3

Use sandpaper to lightly sand inside the line drawn

on the fuselage. Also sand the inside of the canopy

where it will contact the fuselage. Use rubbing alcohol

and a paper towel to remove any dirt from both the canopy

and fuselage.

 Step 4

Apply a thin bead of canopy glue to the inside edge of the

canopy. Position the canopy onto the fuselage and use

masking tape to hold the canopy to the fuselage until the

canopy glue has had time to fully cure.

Section 14: Final Assembly