User Manual

42
Ailerons
Check to make sure the clevis is located in the outer hole
of the control horn. If not, slide the clevis retainer forward,
disconnect the clevis, connect it in the correct location,
and slide the clevis retainer back into position.
Connect the aileron servo leads as described in
the previous section. Center the aileron trim on
the transmitter.
Turn on the transmitter, then the receiver. Thread the clevis
as necessary until the aileron is even with the wing tip.
Elevator
Connect the elevator clevis to the center hole on the
elevator control horn.
Center the trim lever for the elevator on the transmitter.
With the radio system on, thread the clevis until the
elevator is aligned with the stabilizer. Slide the clevis
retainer onto the clevis to secure its location.
Section 15: Centering the Control Surfaces