User Manual
52
Required Tools and Adhesives:
• Plier (2) • Drill bit: 1/16" (1.5mm)
Step 1
Remove the flap linkage from the aircraft.
Step 2
Remove the flap linkage stay from the wing. Be careful
when removing the stay as not to damage the wing.
Step 3
The “Z” bend in the linkage will need to be rotated
90-degrees to connect to the servo. Use two pairs of
pliers, one to hold the linkage, and the other to twist
the “Z” bend.
Step 4
Remove the covering from the wing for the flap servo. This
area is in the left wing panel right next to where the flap
linkage stay was located.
Step 5
Place the servo (not included) into the opening. Use a
1/16" (1.5mm) drill bit to drill holes in the underlying
wood for the servo mounting screws. Once the holes are
drilled, use the four screws that were provided with the
servo to secure it into position.
Note: Make sure to read the instructions
included with the servo for installing the
grommets and brass eyelets.
Step 6
Plug the servo into the 5th channel of the receiver.
Section 23: Adding a Flap Servo