User Manual

8
Required Items:
• Wing (right and left) • Aileron (right and left)
• Flap (right and left
• CA hinge (12)
Required Tools and Adhesives
• T-pins • Drill
• Drill bit: 1/16" (1.5mm) • Thin CA
• 6-minute epoxy • Sandpaper
• Paper towel • Rubbing alcohol
• Mixing stick • Toothpick
  Step 1
Remove the tape holding the flap and aileron on the
wing. Locate three hinges and place a T-pin in the center
of each hinge. This will help center the hinge when slid
into the wing.
  Step 2
Drill a 1/16" (1.5mm) hole into the center of the three
aileron hinge slots. This creates a tunnel so the thin CA
used to glue the hinges can fully penetrate the hinge.
Repeat the process for the hinge slots in the wing as well.
  Step 3
Slide the three hinges into the slots in the aileron.
Align the slot in the hinge with the hole drilled in the
previous step.
Section 1: Hinging the Ailerons and Flaps