User Manual

13
    Step 7
Tie the string onto the servo extension. Gently pull the
extension through the wing using the string. Untie the
string when the servo lead has been pulled through. Use
tape to secure the servo lead to the wing to prevent it from
falling back into the wing panel.
    Step 8
Place the hatch in position on the wing. Measure in 1/8"
on all four sides of the hatch, as the intersection of these
lines will be on the hard points located underneath the
hatch. Drill four 1/16" holes at the intersections of the
lines and into the hard points. Remove the hatch and
enlarge the holes using a 7/64" drill bit.
    Step 9
Secure the hatch using four #2 x 1/2" screws.
Section 2: Aileron and Flap Servo Installation