User Manual

15
    Step 14
Install one of the #2 x 1/2" screws into a hole drilled, then
remove it. Place 2–3 drops of thin CA into the hole to
harden the wood. This will eliminate the potential of the
screw pulling out of the wood. Repeat this for each of the
three holes.
    Step 15
Attach the control horn using three #2 x 1/2" screws.
 Step 16
Repeat Steps 1 through 15 for the remaining aileron servo.
 Step 17
Repeat Steps 1 though 15 for the flap servo, substituting
a 6" servo extension and a 4-40 x 1
1
/
2
" threaded rod for
the flap linkage.
Section 2: Aileron and Flap Servo Installation