User Manual

17
  Step 5
Assemble and install the linkage using the 4-40 x 1/2"
threaded rod, ball end and metal clevis. Attach the clevis
to the retract actuator, and use a 2-56 socket head screw,
#2 standoff, #2 washer and 2-56 nut to attach the ball-link
to the servo arm. (Hardware not included, use genuine
Hangar 9
®
hardware and servo arms for the installation
of your retract servo.)
  Step 6
Check that the retract fully locks at both up and down
positions without stalling the servo. Adjust the length of
the linkage and the position of the linkage at the servo
until both up and down locked positions are achieved.
Section 3: Retract Installation