User Manual
18
Step 7
Once the retracts are fully adjusted, install them
into the wing and secure their position using four
6-32 x 1/2" screws.
Step 8
Attach the retract servo hatches using two #2 X 1/2"
sheet metal screws.
Step 9
Check the fit of the gear door to the retract strut and wing
panel. Mark the location for the three mounting holes from
the retract strut onto the gear door. Drill three 1/8" holes
for mounting the gear door to the retract strut. Attach the
gear door to the retract using two 4-40 x 1/2" socket head
screws near the wheel, and one 4-40 x 3/8" socket head
screw near the retract mechanism.
Step 10
Repeat Steps 1 through 9 for the remaining retract.
Section 3: Retract Installation