User Manual
19
Required Parts
• Wing assembly • Wing joiner
• Wing dowels (2) • Fuselage
• Plywood wing bolt plate (2)
• 1/4-20 x 2" nylon bolts (2)
• Air scoop
• Plastic guide tubes (2)
• Plywood tube locators (2)
Required Tools and Adhesives
• Ruler • Masking tape
• 30-minute epoxy • 6-minute epoxy
• Rubbing alcohol • Paper towels
• Screwdriver (slotted) • Hobby knife
• Felt-tipped pen • Razor saw
• Medium grit sandpaper
Step 1
Locate a 1/4" x 2" wing dowels. Draw a line 5/8" from
one end of the dowel.
Step 2
Glue the dowel into the wing using 5-minute epoxy. Apply
epoxy to both the holes in the wing and dowels. Slide the
dowel in up to the line drawn in the previous step. Clean
up any excess epoxy using a paper towel and rubbing
alcohol. Allow the epoxy to fully cure before proceeding.
Step 3
Locate a plywood wing bolt plate. Slide one of the
1/4-20 x 2" nylon bolts through the hole. Slide the bolt
into the hole in the wing, aligning the plate so the edge
at the root is parallel to the wing root. Trace around the
plate using a felt-tipped pen.
Section 4: Wing Assembly