User Manual

20
  Step 4
Use a hobby knife with a brand new blade to remove
the covering 1/16" inside of the line drawn. Use care
not to cut into the underlying balsa, as this will weaken
the wing structure.
  Step 5
Mix 1/2 ounce of 6-minute epoxy and coat both the
wing and plywood plate. Place the plate back onto the
wing and clamp it in position. Remove any excess epoxy
using paper towels and rubbing alcohol.
Caution: Use scrap plywood under the clamps
to prevent damage to the balsa wing structure.
  Step 6
Slide the wing bolt into position. Use a felt-tipped pen to
trace around the heads of the wing bolts.
  Step 7
Remove the wing bolts from the wing. Locate the
plywood tube locators and use medium CA to glue the
locators in position. Use the lines drawn around the
bolt heads as a guide.
  Step 8
Repeat Steps 1 through 7 for the remaining wing panel.
Section 4: Wing Assembly