User Manual

 Step 12

Completely coat one half of the wing joiner with epoxy.

Be sure to apply epoxy to the top and bottom of the joiner

also. Insert the epoxy-coated side of the joiner into the

wing joiner cavity up to the mark on the joiner. If you have

used enough epoxy, it will ooze out of the cavity as the

joiner is installed.

 Step 13

Apply a generous amount of epoxy to the joiner cavity

of the opposite wing panel. Apply epoxy to the exposed

portion of the wing joiner. And finally, apply epoxy to root

wing rib of both panels.

 Step 14

Carefully slide the wing panels together. Apply enough

pressure to firmly seat the two wing panels together,

causing any excess epoxy to ooze out from between the

panels. There should be no visible gaps between the

panels. Use masking tape to securely hold the wing panels

together. Use rubbing alcohol and a paper towel to remove

the excess epoxy. Allow the epoxy to fully cure before

continuing to the next section.

 Step 15

Place a piece of wax paper between the fuselage and

wing at the rear of the wing. Check the fit of the wing to

the fuselage and make any adjustments necessary to the

wing bolt holes to attach the wing using the two

1/4-20 x 2" nylon bolts.

Section 4: Wing installation