User Manual

23
 Step 16
Use medium grit sandpaper to lightly sand the inside edge
of the air scoop.
 Step 17
Position the air scoop onto the wing bolt plates. It should
fit snuggly on the plates. Remove the air scoop, and apply
a thin bead of 6-minute epoxy around the bottom edge
of the air scoop. Place it back into position and allow the
epoxy to cure before proceeding.
 Step 18
Remove the wing from the fuselage.Try to keep the wing
bolts in the wing. Once the wing is removed, slide the
plastic guide tubes through the scoop and over the heads
of the wing bolts.
Note: The ends of the tubes will lock into the
plywood tube locators when fully installed.
 Step 19
Remove the wing bolts by sliding them out through
the tubes. Remove the tubes and roughen them using
medium sandpaper.
 Step 20
Apply a thin bead of 6-minute epoxy around one end of
the tubes. Slide the tube in position through the air scoop
and into the plywood tube locators. Use a paper towel to
clean up any excess epoxy from the air scoop.
 Step 21
Remove the excess tube using a razor saw and
hobby knife.
Section 4: Wing installation