User Manual
29
Step 4
Mark a location on the firewall for the throttle
pushrod. Use a 5/32" drill bit to drill the location for
the throttle tube. Roughen the tube using sandpaper,
and then slide it into position. Use medium CA to glue
the tube to the firewall.
Step 5
Attach a brass connector to the throttle arm using the
connector backplate. Slide the pushrod through the
connector and into the tube.
Important: Be sure to differentiate between
the vent and fuel pickup tube. Once the
tank is mounted inside the fuselage, it
will be difficult to tell the tubes apart.
Step 6
Position the tank inside the fuselage. Use 1/2" foam to
isolate the tank from the fuselage.
Step 7
Route the fuel lines through the firewall. Install the
muffler to the engine. Attach the appropriate lines to the
carburetor and muffler.
Section 8: Engine Installation