User Manual

Required Parts

• Fuselage assembly • 1/4" foam

• Receiver • Receiver battery

• Switch harness • Brass connector (2)

• 3mm x 6mm screw (2)

• Servos (4) (not included)

• Connector backplate (2)

Required Tools and Adhesives

• Thin CA • Hobby knife

 Step 1

Install the recommended servo hardware (grommets

and eyelets) supplied with your radio system onto four

servos (elevator (2), rudder and throttle). Install the

servos as shown. Secure the servos using the screws

provided with the servos.

 Step 2

Mount the radio switch in the side of the fuselage. Glue

small scraps of plywood to the balsa sheeting inside the

fuselage to give the screws something to bite into.

Note: Using two standard rotation servos and

a standard Y-harness for the elevators will

result in them moving in opposite directions

instead of the same direction. As such, the

elevator servo installation will either require

the use of one reversed rotation servo and

one standard rotation servo or a reversing

Y-harness. It is highly recommended to use a

computer radio or a JR

MatchBox

™

to link

the two elevator servos to operate properly.

 Step 3

Wrap the receiver and receiver battery in 1/4" foam.

Plug the servos and servo extensions into the receiver.

Mount the receiver and battery in the fuselage so they

won’t move in flight.

Section 11: Radio Installation