User Manual

35
 Step 4
Route the antenna to the rear of the fuselage. Do not cut
the antenna wire, as this will greatly reduce the range of
your radio system.
  Step 5
Center the elevator servo electronically using the radio
system. Install a servo arm onto one of the elevator
servos. Physically place the elevator control surface in
neutral. Mark the pushrod where it crosses the holes in
the servo arm.
  Step 6
Bend the wire 90 degrees at the mark made in the
previous step. Cut the wire 1/2" above the bend.
  Step 7
Slide the wire through the outer hole in the elevator servo
arm. Secure the wire using a nylon wire keeper.
Note: The servo arm will need to be drilled out
using a 7/64" drill bit to accept the control rod.
 Step 8
Repeat Steps 5 through 7 for the remaining elevator servo.
 Step 9
Attach a brass connector to the rudder servo arm using a
connector backplate. The connector is placed in the hole
in the servo arm closest to the center of the arm.
Section 11: Radio Installation