User Manual

36
 Step 10
Repeat Steps 5 through 7 for connecting the rudder
pushrod. The pushrod from the tail wheel passes
through the connector. Center the tail wheel, then
secure the tail wheel pushrod in the connector using a
3mm x 6mm screw.
 Step 11
Install a brass connector to the throttle servo arm.
Center the throttle stick and trim with both the receiver
and transmitter on. Install the throttle servo arm in the
neutral position as shown, passing the throttle pushrod
wire through the connector.
 Step 12
Move the throttle stick and trim to low. Check to make
sure the carburetor will move to the low position when
operating the servo. Install two 3mm x 6mm screws
to secure the easy connector to the throttle pushrod.
Check the movement of the throttle to verify there is no
binding at either low or high throttle. If there is, make the
necessary adjustment to eliminate any binding. Install the
throttle servo arm screw when complete.
Section 11: Radio Installation