User Manual
38
Step 5
Install the propeller and spinner by installing the backplate
then the center block (for the scale propeller). Secure the
block using the engine hardware. Place the spinner into
position and slide the blades through the spinner cone
and into the block. Secure the spinner to the backplate
using six #4 x 1/2" sheet metal screws.
Note: The scale propeller is shown in the
photo. Do not attempt to fly the aircraft with
this propeller as it is for display only.
Note: Check to make sure the spinner does
not rub against the front of the fuselage. If so,
loosen the engine mounting bolts, slide the
engine forward until the spinner can turn freely,
then re-tighten the engine mounting bolts.
Step 6
Cut out the instrument panel decal and apply.
Step 7
Install the cockpit accessories (including a pilot if you so
choose) using medium CA or Shoo Goo.
Step 8
Glue the canopy to the fuselage using RC560 canopy glue.
Tape the canopy in place with masking tape and allow the
glue to cure overnight.
Section 12: Final Assembly