User Manual

 Step 9

Locate the decal sheet and cut out the decals for the

P-51D using a sharp hobby knife and scissors. Use

the photos on the box to aid in locating the decals.

Use a spray bottle with 2–3 drops of dish soap added

to the water and spray both the fuselage and sticky side

of the decal. This will allow you to reposition the decal

if necessary. Once satisfied with the position, use a

paper towel to squeegee out the water. Allow the decal

to dry overnight.

Note: There may be some clouding under the

decal, but this will go away as the decal dries.

  Step 10

Locate the positions for the pylon mounting screws

on the bottom of the wing. This is done by gently

pressing on the covering with your index finger. Remove

the covering using a sharp hobby knife.

  Step 11

Slide the two 1/4"-20 nylon bolts through the bomb and

though the bomb pylon.

  Step 12

Use a flat blade screwdriver to attach the bomb and pylon

to the wing using the 1/4-20 nylon bolts.

 Step 13

Repeat Steps 10 though 12 for the remaining bomb

and pylon.

Section 12: Final Assembly