User Manual

8
Required Parts
• Right and left wing panels w/ailerons
• Wing assembly • Nylon flap hinges (6)
• CA hinges (6)
Required Tools and Adhesives
• Thin CA • CA remover/debonder
• Paper towel • T-pins
• Drill • Drill bit: 1/16"
• 30-minute epoxy • Paper towels
• Rubbing alcohol • Petroleum jelly
  Step 1
Use a 1/16" drill bit to drill into the wing and aileron at the
center of each hinge. This allows the CA to wick farther
into the surfaces for better hinge installation.
  Step 2
Locate three CA hinges and place a T-pin in the center of
the hinge as shown. Slide each of the three hinges into
the aileron so the T-pin is resting against the leading edge
of the aileron. The slot in the hinge aligns with the hole
drilled in Step 1.
  Step 3
Slide the aileron onto the wing until there is only a slight
gap between the aileron and wing panel. Remove the
T-pins and snug the aileron against the wing panel. Slide
the aileron towards the wing tip until there is only a 1/32"
gap between the end of the aileron and wing tip.
Note: Do not use CA accelerator during
the hinging process. The CA must be
allowed to soak into the hinge to provide
the best bond. Using accelerator will not
provide enough time for this process.
Section 1: Aileron and Flap Installation