User Manual

9
  Step 4
Deflect the aileron and apply thin CA to the hinge. Apply
enough CA to completely saturate the hinge. Use care
not to deflect the aileron so it pulls away from the wing.
When the hinge is glued in place, there should be no
more than a 1/64" hinge gap maintained throughout the
length of the aileron. Turn the wing panel over, deflect the
aileron in the opposite direction, and apply thin CA to the
other side of the hinges.
  Step 5
Use CA remover/debonder and a paper towel to remove
any excess CA accumulated on the wing or aileron
surface. Allow time for the CA to completely cure before
moving to the next step.
  Step 6
Firmly grasp the wing and aileron and gently pull on the
aileron to ensure the hinges are secure and cannot be
pulled apart. Use caution when gripping the wing and
aileron to avoid crushing the structure.
  Step 7
Work the aileron up and down several times to work in the
hinges and check for proper movement.
Section 1: Aileron and Flap Installation