User Manual

27Hangar 9 P-51D Mustang Sport 40 Assembly Manual
 Step 8
Use a pencil to mark the position of the servo mounting tabs
on the cover.
 Step 9
Use medium grit sandpaper to lightly sand the end of the
block that will rest against the servo cover.
Sand this end
 Step 10
Use 30-minute epoxy to glue the servo mounting blocks
to the servo cover. Allow the epoxy to fully cure before
proceeding.
 Step 11
Repeat Steps 2 through 10 to prepare the remaining servo
cover for the servo.
 Step 12
Position the servo between the servo mounting blocks.
Use a pencil to transfer the positions for the screws to the
mounting blocks.
 Step 13
Use a drill and 1/16-inch (1.5mm) drill bit to drill the four
holes for the servo mounting screws.
 Step 14
Apply 2–3 drops of thin CA in each hole to harden the
surrounding wood. This will help in preventing the screws
from vibrating loose.