User Manual
5
Required Parts
• Fuselage • Receiver
Required Tools and Adhesives
• Phillips screwdriver • Hobby knife
Step 1
Plug the elevator, rudder and throttle servo leads into your
receiver. Plug the "Y" harness into the aileron channel of
the receiver. Plug the switch harness and battery leads
into the receiver as well. Install the flat radio foam into the
fuselage, followed by the die-cut foam.
Note: There is a tube located under the
elevator servo for the antenna wire. Route the
wire through this tube to the tail of the aircraft.
Step 2
Place the remaining flat radio foam over the receiver and
battery. Secure the foam to prevent the receiver and battery
from moving from their location.
Note: The windows are not show for clarity.
Section 1: Receiver Installation