User Manual
12
Step 4
Once all the connectors have been installed, use heat
shrink tubing to insulate them. If not insulated, they could
short and damage the speed controller.
Step 5
Repeat Steps 1 through 4 to install a connector onto the
battery lead of the speed control that matches the one on
your battery.
Step 6
Remove the cowling and propeller from the fuselage. Plug
the motor leads from the motor to the speed control.
Step 7
Use double-sided tape or sticky back hook and loop to
secure the speed control inside the fuselage. Make sure it
can't move around, and that the wires going to the motor
are secure and won't interfere with the operation of the
motor.
Step 8
Pass the hook and loop straps through the battery floor as
shown.
Section 2: Motor and Cowling Installation