User Manual

19
Required Parts
• Fuselage • Clevis
• Clevis retainer • Control horn
• Wing strut mount (2) • #4 x 3/8" screw (4)
• 19
3
/
4
" pushrod dowel • 6" pushrod wire
• Pushrod wire (32”)
• 2
1
/
8
" heat shrink tubing (2)
• 2mm x 12mm screw (3)
• 7
1
/
4
" pushrod wire (2)
Required Tools and Adhesives
• Phillips screwdriver • Hobby knife
• Drill • Drill bit: 3/32", 5/64"
• Heat gun • Medium CA
• Thin CA • Felt-tipped pen
 Step 1
Remove the covering for the wing strut mount. The
opening is located above the rear landing gear mount.
 Step 2
Slide the wing strut mount into the opening. Secure the
mount using two #4 x 3/8" screws.
 Step 3
Install the recommended servo hardware (grommets and
eyelets) supplied with the servos into the throttle, rudder,
and elevator servos.
 Step 4
Use the hardware provided with the servos to mount them
in the fuselage.
Section 4: Servo Installation (Fuselage)