User Manual

20
 Step 5
Place a clevis retainer onto a clevis. Thread the clevis
onto a 32" pushrod wire. Remove the backplate from a
control horn, and then attach the clevis to the control
horn. Slide the pushrod into the rudder pushrod tube in
the fuselage. Position the horn so the holes align with the
hinge line. Use a felt-tipped pen to mark the positions for
the three mounting bolts.
Align holes with hinge line
 Step 6
Drill the locations marked in the previous step using
a 3/32" drill bit. Place a few drops of thin CA into
each of the holes to harden the balsa. Attach the control
horn using three 2mm x 12mm screws and the control
horn backplate.
 Step 7
Plug in the rudder servo to the radio system. Center the
trims on the transmitter to center the rudder servo. Hold
the rudder in neutral. Use a felt-tipped pen to mark the
pushrod wire where it crosses the servo arm.
Section 4: Servo Installation (Fuselage)