User Manual

21
 Step 8
Remove the pushrod wire from the fuselage and remove
the clevis. Bend the pushrod wire at the mark. Slide
the pushrod back into the fuselage from the radio
compartment, and then put the clevis back onto the
wire. Use a pushrod wire keeper to secure the pushrod
wire to the servo arm.
 Step 9
Locate the 19
3
/
4
" wood pushrod for the elevator. Drill two
5/64" holes through the dowel, 1" and 1
1
/
4
" from one end.
The holes must be parallel to each other.
 Step 10
Cut a groove into the pushrod from the hole to the end
of the pushrod. Repeat for the opposite side so you end
up with two grooves. The elevator pushrod wires will
rest in these grooves.
 Step 11
Locate the two 7
1
/
4
" pushrods. Make a bend in one
pushrod 1/4" from the non-threaded end. The remaining
pushrod is bent 1/2" from the non-threaded end.
 Step 12
Test fit the two wires. The wire bent at 1/2" is placed in
the hole closest to the pushrod end. You will have to
trim the wire down after the bend so it won’t interfere
with the other pushrod. Once fit, use medium CA to
glue the wires to the dowel.
Section 4: Servo Installation (Fuselage)