User Manual

 Step 13

Slide the 2

" piece of heat shrink over the wires and

dowel. Use a heat gun or lighter to shrink the tubing. Once

the tubing has been shrunk, apply thin CA to each end of

the shrink to complete this part of the pushrod assembly.

 Step 14

Repeat Steps 9 through 13 for the opposite end of

the dowel, but only drill one hole 1" from the end and

prepare one 6" pushrod wire with a bend 1/4" from the

non-threaded end.

 Step 15

Slide the elevator pushrod wire in position into the

fuselage. It may take some time to get it in, so be

patient. Slide a clevis retainer onto two clevises, and

then thread them onto the pushrod wires at the aft end

of the fuselage. This will prevent the pushrod wire from

falling out of the fuselage.

 Step 16

Plug the necessary servo leads into the receiver. This

includes the switch harness and battery leads as well.

Use double-sided tape or hook and loop to secure the

receiver and battery inside the fuselage.

Note: There is a tube located under the

elevator servo for the antenna wire. Route the

wire through this tube to the tail of the aircraft.

 Step 17

Mount the receiver switch to the side of the fuselage.

Section 4: Servo Installation (Fuselage)