User Manual

25
 Step 5
Position the landing gear to the bottom of the fuselage.
Secure the position of the gear using four landing gear
straps and eight 3mm x 10mm screws.
Required Parts
• Stabilizer assembly • Fuselage
• #4 washer (4) • #2 washer (3)
• 2-56 x 1/2" screw (3) • 2-56 nut (3)
• Clevis (4) • Clevis retainer (4)
• Cable ends (4) • Brass crimps (8)
• Cable • Pushrod wire keeper
• Control horn (2)
• 2mm x 12mm screw (6)
• Brass fitting (small) (6)
• Brass fitting (large) (2)
• #2 x 1/2" sheet metal screw
• 4-40 x 1/2" socket head screw (4)
Required Tools and Adhesives
• Threadlock • Pliers
• Drill • Drill bit: 3/32"
• Adjustable wrench • Crimping tool
• Phillips screwdriver (small) • Threadlock
 Step 1
Slide the stabilizer halves into the slot in the fuselage.
Use four 4-40 x 1/2" screws and four #4 washers to
secure the stabilizer. Use threadlock to prevent the
screws from vibrating loose during flight.
 Step 6
Secure the tail wheel using the small wheel collar
and setscrew.
Section 7: Installing the Stabilizer
Section 6: Landing Gear Installation