User Manual
26
Step 2
Attach a control horn to one of the elevator clevises. Line
the holes in the control horn with the hinge line and mark
the location for the mounting crews onto the elevator.
Step 3
Drill the holes using a 3/32" drill bit. Use thin CA to
harden the holes. Mount the control horn using the horn
backplate and three 2mm x 12mm screws.
Step 4
Repeat Steps 2 and 3 for the remaining elevator
control horn.
Step 5
Attach the elevator pushrod to the servo arm of the
elevator servo using a pushrod wire keeper.
Step 6
Bend each of the fittings (small and large) to about a
45-degree angle.
Step 7
Attach the large brass fittings at the bottom rear of the
fuselage using the #2 x 1/2" sheet metal screw.
Section 7: Installing the Stabilizer