User Manual

 Step 8

Attach the small brass fitting to the fin and stabilizer

using 2-56 x 1/2" screws, #2 washers and 2-56 nuts.

Fittings are placed on both sides of the rudder and

the top and bottom of the stabilizer.

 Step 9

Slide a clevis retainer onto a clevis. Thread a cable end

into the clevis. Prepare four of these connectors.

  Step 10

Cut the cable into four equal pieces. Prepare one cable by

sliding the cable through a crimp, through the cable end,

then back through the crimp twice. Pull the excess cable

tight and use a crimping tool to complete the job. Repeat

for all four of the ends.

Section 7: Installing the Stabilizer