User Manual

28
 Step 11
Attach the four connectors to the brass fittings
of the stabilizer.
 Step 12
Repeat Step 10, only passing the cable through the brass
fittings instead of the cable ends. The cables should have
very light tension.
Note: Be careful not to overtighten
cables as you may introduce a warp into
the tail surfaces.
Required Parts
• Wing • Fuselage
• 4-40 lock nut (16) • 4-40 nut (4)
• Strut support anchor (4) • Strut bracket (4)
• Strut end (4) • Strut (narrow) (L&R)
• Strut (wide) (L&R) • Strut brace (long) 2
• Strut brace (short) (2) • Strut cross brace (2)
• #2 x 3/8" screw (4) • Fuselage hatch
• 1/4-20 x 2" nylon bolt (2)
• 4-40 x 1/2" socket head screw (24)
Required Tools and Adhesives
• Hex wrench • Adjustable wrench
• Threadlock
• Phillips screwdriver (small)
  Step 1
Attach two strut brackets to the bottom of the wing using
four 4-40 x 1/2" socket head screws. Use threadlock to
prevent the screws from loosening during flight.
Section 7: Installing the Stabilizer
Section 8: Wing Installation