User Manual

17
ooo Step 4
Lightly sand the servo mounting blocks on the edge where
they will be glued to the servo cover. This will allow the
epoxy to hold onto the block, providing a more secure
bond between the cover and blocks.
ooo Step 5
Use 30-minute epoxy to attach the two mounting blocks to
the servo cover. Use clamps or tape to hold the blocks in
position until the epoxy fully cures.
ooo Step 6
Transfer the locations for the servo mounting screws onto
the servo mounting blocks using a pencil.
ooo Step 7
Drill four holes for the servo mounting screws using a
drill and 5/64-inch (2mm) drill bit.
Section 2: Aileron and Flap Servo Installation