User Manual

Required Parts

• Stabilizer/elevator (right and left)

• 4-40 x 1/2-inch socket head screws (10)

• #4 washers (4) • 4-40 lock nut (4)

• Tail rigging (long tab) (2) • Tail rigging tab (8)

• Tail rigging (medium tab) (2)

• Tail rigging (short tab, short cable) (4)

• 1

-inch (30mm) pin

• 13/16-inch (21mm) pin

Required Tools and Adhesives

• Threadlock • Adjustable wrench

• Hex wrench: 3/32-inch • Pliers

 Step 1

Slide the stabilizer pins into one of the stabilizer halves.

The longer 1

-inch (30mm) pin is inserted toward the

leading edge, while the shorter 13/16-inch (21mm) pin is

inserted toward the elevator.

 Step 2

Attach one half of the stabilizer using two 4-40 x 1/2-inch

socket head screws and two #4 washers. Leave the screws

loose until instructed to tighten them.

 Step 3

Slide the remaining stabilizer into position and secure it

using two 4-40 x 1/2-inch socket head screws and two #4

washers. Tighten all four screws at this time.

Note: Make sure to use threadlock on the

screws to prevent them from vibrating loose.

Section 4: Stabilizer/Elevator Installation