User Manual
29
o Step 4
Use the screws supplied with the servo and a #1 Phillips
screwdriver to secure the servo to the radio tray.
Step 5
Repeat Steps 1 through 4 to install the elevator servo.
Step 6
Wrap the receiver battery in foam and secure it to the
radio tray using the supplied hook and loop strap.
The receiver is mounted on the battery and should be
positioned to avoid vibrations from being transferred
through the airframe into the receiver. Install your switch
harness at this time as well.
Step 7
When using a remote receiver, place it as far as possible
from the main receiver and at a different level in the
fuselage for the best results. The higher the remote
receiver can be mounted in the fuselage, the better.
Section 5: Radio Installation