User Manual

31
 Step 12
Slide the two 5/32-inch wheel collars onto the 32-inch
(813mm) elevator pushrod. Secure the collars near the
bend using a 3mm x 8mm machine screw and #2 Phillips
screwdriver. The wheel collars will be positioned later.
 Step 13
Repeat Steps 8 through 11 to install the elevator pushrod,
attaching the pushrod to the outer hole on the servo arm
and the center hole of the control horn.
 Step 14
Thread a clevis on the remaining 31
1
/
4
-inch (794mm)
pushrod. Slide the pushrod into the pushrod tube from
outside the fuselage and attach the clevis to the center
hole of the elevator control horn.
 Step 15
The pushrod will pass through the two wheel collars that
were installed in Step 12. The collars are then tightened to
hold the two pushrods together. Apply 30-minute epoxy to
the pushrods between the two collars as well at this time.
Note: Make sure to use threadlock on the
screws to prevent them from vibrating loose.
Section 5: Radio Installation