User Manual

Required Parts

• Engine mount • 8-32 lock nut (4)

• Clevis • Clevis retainer

• Engine mount plate (2) • Fuel tank

• 11

-inch (300mm) throttle pushrod tube

• 8-32 x 3/4-inch machine screw (4)

• 8-32 x 1-inch machine screw (4)

• 17

-inch (450mm) throttle pushrod

Required Tools and Adhesives

• Threadlock • Ruler

• Foam rubber • Fuel dot

• Pencil • Side cutter

• Drill • Sandpaper

• Drill bit: 11/64-inch (4.5mm)

 Step 1

Attach the mount to the firewall using four 8-32 x 3/4-inch

machine screws and four #8 washers.

Note: Make sure to use threadlock on the

screws to prevent them from vibrating loose.

 Step 2

Temporarily install the rear 8-32 x 1-inch machine screws

and 8-32 lock nuts to attach the mounting plates to the

mount. Finger-tighten the screws at this time.

Note: The motor mount plates have a textured

side that faces the mount when installed.

 Step 3

Slide the engine between the mount and mounting

plates. Install the remaining 8-32 x 1-inch machine

screws and 8-32 lock nuts at the front of the mounting

plates. Position the engine so the drive washer is

-inch (118mm) forward of the firewall. Tighten

all four 8-32 x 1-inch machine screws evenly to secure

the position of the engine.

Section 6: 2-Stroke Engine Installation