User Manual

Required Parts

• Engine mount • 8-32 lock nut (4)

• Engine mount plate (2) • Fuel tank

• 11

-inch (300mm) throttle pushrod tube

• 8-32 x 3/4-inch machine screw (4)

• 8-32 x 1-inch machine screw (4)

• 17

-inch (450mm) throttle pushrod

Required Tools and Adhesives

• Threadlock • Ruler

• Foam rubber • Fuel dot

• Pencil • Side cutter

• Drill • Sandpaper

• Drill bit: 11/64-inch (4.5mm)

 Step 1

Attach the mount to the firewall using four 8-32 x 3/4-inch

machine screws and four #8 washers.

Note: Make sure to use threadlock on the

screws to prevent them from vibrating loose.

 Step 2

Temporarily install the rear 8-32 x 1-inch machine screws

and 8-32 lock nuts to attach the mounting plates to the

mount. Finger-tighten the screws at this time.

Note: The motor mount plates have a textured

side that faces the mount when installed.

 Step 3

It may be necessary to rotate the carburetor on your

engine in order to attach the throttle linkage. If the

carburetor arm and linkage will interfere with the engine

mount, rotate the carburetor as shown.

Section 7: 4-Stroke Installation